Maytag Appliance Error Codes — Complete Repair Reference

Maytag appliances (manufactured by Whirlpool Corporation) use a similar F/E error code system as Whirlpool but with some Maytag-specific variations. This guide covers the codes our technicians encounter regularly on Maytag washers, dryers, dishwashers, and ranges across Northern Virginia homes.

Maytag Washer Error Codes

Maytag Bravos, Centennial, and commercial-grade washers display F/E codes during or after cycles.

Code	Meaning	What It Means & Repair Cost
F0 E2	Excess Suds	Too much detergent used. Switch to HE detergent and reduce amount. The washer adds extra rinse cycles to clear suds.
F3 E1	Pressure Switch Error	The water level sensor has failed. The pressure hose may be kinked or clogged. Sensor: $60–$100.
F5 E2	Door Lock Error	The front-load door lock is not engaging. Items stuck in the door gasket can cause this. Lock assembly: $80–$150.
F5 E3	Lid Lock Error (Top Load)	The lid lock mechanism has failed. Common on Bravos models. Lid lock: $60–$120.
F7 E1	Motor Fault	The drive motor is not reaching proper speed. Check the rotor position sensor and motor control board. Repair: $100–$280.
F8 E1	No Water Detected	Water is not entering the washer. Check supply valves and clean inlet screens. Inlet valve: $90–$160.
F9 E1	Long Drain	The drain cycle exceeded 8 minutes. Clean the drain pump filter and check the drain hose. Pump: $120–$200.
Sd	Suds Detected	Similar to F0 E2 but a softer warning. Reduce detergent and switch to HE formula.
F7 E5	Shifter Fault	The transmission shifter/actuator has failed. The washer cannot switch between agitate and spin. Actuator: $100–$180.

Maytag Dryer Error Codes

Maytag dryers share many codes with Whirlpool since they are built on the same platform.

Code	Meaning	What It Means & Repair Cost
F2 E4	Exhaust Restriction	Dryer vent blockage detected. Professional vent cleaning required to restore airflow and prevent fire.
F3 E1	Exhaust Thermistor	Temperature sensor open circuit. Sensor: $50–$90.
F3 E3	Inlet Thermistor	The inlet temperature sensor has failed. Sensor: $50–$90.
F4 E1	No Heat	Electric: heating element open. Gas: igniter or solenoid failure. Element: $100–$180.
F4 E3	Inlet Temperature High	The dryer is overheating at the inlet. Often caused by restricted venting. Clean the vent system.
F6 E2	UI/MCU Communication	The user interface board and motor control board have lost communication.

Maytag Dishwasher Error Codes

Maytag dishwashers display error codes or use LED blink patterns depending on the model.

Code	Meaning	What It Means & Repair Cost
F1 E1	Temperature Sensor	NTC sensor failure. The dishwasher cannot monitor water temperature. Sensor: $50–$90.
F5 E2	Door Latch Error	The door latch switch is not engaging. Check for obstructions. Latch: $50–$100.
F6 E4	No Water Fill	Water not entering the unit. Check supply valve and clean inlet filter screen.
F8 E1	Slow Drain	Water draining too slowly. Clean the drain path, check pump and hose.
F8 E4	Overflow Warning	Float switch triggered — too much water in the tub. Float or inlet valve issue.
F9 E1	Diverter Disc Error	The diverter that routes water to upper/lower spray arms has failed. Motor: $80–$140.

Maytag Oven and Range Error Codes

Maytag ovens use the same F-code system as Whirlpool ranges.

Code	Meaning	What It Means & Repair Cost
F1 E0	EEPROM Fault	Control board memory corrupted. Board replacement: $150–$300.
F2 E0	Oven Over Temperature	Oven exceeded safe temperature. Do not use until inspected. Thermostat or relay failure.
F3 E0	Open RTD Sensor	Oven temperature probe has an open circuit. Probe: $40–$80.
F3 E1	Shorted RTD	Probe has a short circuit. Same replacement.
F5 E1	Door Lock Failure	Self-clean door lock malfunction. Lock motor: $80–$160.
F2 E1	Keypad Shorted	A button on the oven keypad is stuck or the membrane overlay is damaged. Overlay/panel: $80–$160.

Our Service Area

We provide Maytag appliance repair and error code diagnosis throughout Northern Virginia including Woodbridge, Dale City, Lake Ridge, Dumfries, Manassas, Gainesville, Lorton, Springfield, Fairfax, and all communities in the 571/703 area code.